solid circuit
英 [ˈsɒlɪd ˈsɜːkɪt]
美 [ˈsɑːlɪd ˈsɜːrkɪt]
网络 固体电路
双语例句
- Solid state electronic device equivalent circuit
固态电子器件等效电路 - Should pay attention to the indoor use of the power supply connected to a reliable, solid, not loose, to prevent short circuit, open circuit;
在室内使用电源时应注意所接电源要可靠、牢固，不能松动，防止短路、断路； - The reliability of solid state tantalum capacitors is related to the serial resistance in a circuit;
②因钽的可靠性与使用线路阻抗有关，如果线路阻抗越小则可靠性越差； - Solid contacts for high-voltage circuit breaker This production is that copper-tungsten and copper bar as one through casting sintering.
高压断路器用整体触头本产品采用烧结熔铸的方法将粉末冶金铜钨合金与铜棒融为一体。 - A bridge type solid state current limiter dealing with short circuit fault in electric power system is proposed.
提出一种处理电力系统短路故障的桥式固态限流技术。 - The hardware of the controller was composed of CPU, signal preprocess circuit, inter-lock circuit, 'Automatic/ Manual' switch circuit, solid state relay circuit and watchdog circuit etc.
研究了激光控制平地技术中的控制器，其硬件主要由CPU、输入信号预处理电路、手动自动方式选择电路、互锁电路、驱动电路、看门狗电路等部分组成。 - Microwave Solid State Circuit Design
微波固态电路设计 - Make use of the capability of semiconductor material with pressure resistance and the better flexibility, to study and manufacture the solid pressure sensor of semiconductor with the integrated circuit craft and the micro engine processing technology, it has two major kind, silica pressure resistance and capacitance.
利用半导体材料的压阻效应和良好的弹性，用集成电路工艺和硅的微机械加工技术来研制固态半导体压力传感器，此种传感器主要有硅压阻式和电容式两种。 - The operation condition of a series feedback type of de-Q circuit is analysed in detail and the main design formula is deduced. The new practical circuit, the solid state scheme of the parallel feedback type de-Q circuit for high voltage and high power is also presented.
本文详细地分析了串联反馈型de-Q电路的工作状态，推导出主要的设计公式，给出了新的实用电路，提出了高压大功率的并联反馈型de-Q电路的固态化方案。 - The PI adjustor and the accurate solid-state pressure sensor are the cores of the control circuit. The close-loop feedback real time adjusting control methods achieves the high control target.
控制电路以比例积分调节器和精密固态压力传感器为核心，采用闭环反馈实时校正控制方法，较好地实现了控制目标。空间群PI； - A comparison of Solid State Relay ( SSR) and traditional relay is made, and a application circuit of SSR is presented with testing data.
本文对固体继电器与传统线圈继电器进行了比较，提出了一种固体继电器应用电路，并给出了试验数据。 - Hybrid circuit breaker ( HCB) combines the advantages of mechanical CB and solid state CB. It is a novel direction of circuit breaker reserch.
混合式断路器（HCB）结合了机械式断路器和固态断路器的优点，是国际上断路器研究的新方向。 - A network synthesis method of microwave solid state power amplifier impedance matching circuit is introduced in this paper.
介绍了微波固态功放阻抗匹配电路的网络综合方法，提出用精确的微带线模型实现匹配电路的新思路。 - A satellite S band solid state power amplifier with high reliability, high efficiency, small size and low weight is fabricated. A temperature compensated circuit is designed to keep the amplifier operating at high linearly with gain almost invariable over full temperature range.
星用固放在高可靠性、高效率、小体积、低重量的基础上，采用温补电路，使部件在全温范围内，功率增益基本保持不变，并维持良好的线性工作状态； - Unbalanced loading of turbine generator induced rotor currents at twice the supply frequency ( 100 Hz), with consequent heating of solid iron and other damping circuit which limited the negative sequence capability of the machine.
汽轮发电机的不平衡负载将使转子感应出两倍工频（100Hz）的涡流，引起转子铁芯及其阻尼电路的发热，从而限制了发电机的负序能力。 - The pulse solid laser power consists of charge circuit, discharge circuit, trigger circuit and simmer circuit.
本文设计的脉冲固体激光器电源系统由以下几部分组成：充电回路，放电回路，泵浦灯的触发电路和预燃电路。 - The static current and voltage relays made of solid state circuit and without DC auxiliary supply are presented.
论述了无需直流辅助电源、用厚膜电路构成的静态型电流和电压继电器。 - The basic structure and principle of solid state circuit breaker ( SSCB) are introduced.
介绍了固态断路器的基本结构和工作原理； - In the experiment of measuring linear expansion coefficient of solid, controlling circuit is designed and the measurement method is improved. The error produced by the asynchronism between linear expansion speed and heat rate of system as well as the respond speed of thermoscope is avoided.
设计了控温电路并改进了测量方法，消除了电热法测量固体线胀系数实验中，由于被测固体棒的线膨胀速度、系统加热速度及测温器响应速度不同步而引起的误差。 - Study of Simulation and Application of Solid State Circuit Breaker
固态断路器的应用与仿真研究 - With the rapid development of millimeter wave solid device, millimeter wave circuit and system are bound to use solid device.
随着微波半导体器件的迅速发展，微波电路乃至整机系统也趋向于固态化、集成化。 - A novel DC hybrid solid state based circuit breaker on IGBT was presented by analyzing and comparing advantages and disadvantages of solid state circuit breakers.
分析和比较了各种固态断路器的优、缺点，提出了适用于直流电力系统的基于IGBT的混合型固态断路器。 - Chapter 3 is mainly on the solid circuit of microwave.
第三章主要介绍了本课题所涉及的微波固态电路，分为四个部分？ - Solid state switchgear with short circuit current limiting
具有短路限流保护的固态开关 - We have carried out a study on the starting characteristics of solid salient-pole synchronous motor ( SSPSM) by the time-stepping finite-element analysis ( FEA) coupled with electric circuit.
采用基于时间步长有限元计算的场路耦合法，分析了实心凸极同步电动机的直接起动过程。 - The key technologies of build solid state switch by series link of thyristors are as follows: trigger circuit of the thyristors, design of the high voltage pulse isolation transformer, produce of the initial control signal, voltage balancing and over voltage protection of the thyristors component.
使用多个晶闸管进行串联涉及到的主要技术有：晶闸管的触发电路设计、高压脉冲隔离变压器的设计、初始控制信号的产生、晶闸管的电压均衡与过压保护技术。 - The simulation results which are compared and analyzed lay a solid theoretical foundation for the design of the soft starter. Secondly, this paper describes the hardware circuit and software design of the soft-start system in detail.
其次详细的阐述了本文设计的软起动器系统的硬件电路结构与软件设计方案。 - Substrate integrated waveguide ( SIW) realizes rectangular waveguide of solid structure on planar circuit substrate. It has some advantages such as high Q-factor, low loss, low cost, easily being integrated on planar circuits.
基片集成波导（SIW）在平面电路基板上实现了矩形波导的立体结构，因此它具有高Q值、低损耗、低成本和易于平面集成等优势。 - The power combining devices and the entire combining system mainly aiming at solid state circuit has been investigated.
以固态电路为主要研究对象，对功率合成器件及合成系统进行了探索性的研究，提出了具有一定创新性的新思路。